LubanCat IoT N6 Pinout



CN3



CN4

MeArm Pi HAT

The MeArm Pi HAT is a joystick controller board for the MeArm Pi Robotic Arm Kit

Features

  • An 8 bit I2C ADC (address 0x48) connected to two analogue joysticks
  • Access to the push buttons of the joysticks on GPIO
  • An RGB LED for output
  • A 6 pin port to connect to the servos on the arm

Power can be supplied to the Pi through the HAT or direct in to the Pi, but the servos are only supplied through the HAT to avoid strain on the Pi power supply.

The pinout of the 6 pin connector is:

+5v Left Servo Grip Servo
GND Base Servo Right Servo

Additionally the I2C and power lines are brought out on to a header for easy expansion with the following pinout from top to bottom:

  1. SDA
  2. 3V3
  3. SCL
  4. GND

Details

MeArm Pi