LubanCat IoT N6 Pinout



CN3



CN4

Audio Z

The Fe-Pi Audio is designed to provide a complete low cost audio solution for Raspberry Pi 2, 3, and Zero, needing line-in, line-out, headphone-out/mic-in, and stereo speakers.

Features

  • SPI, UART, and I2C 2.54mm(.100) breakout pads are available for external use.
  • Raspberry Pi 2, 3 PCB footprint.
  • SGTL5000 low power stereo codec.
  • 3.5 mm, 4 contact, jack for Headphone/MIC (black).
  • RCA jacks for stereo Line In, and Line Out.
  • 4 pin screw terminal for Speaker Out.
  • At minimum, 3 Amp power supply is recommended for the Raspberry Pi, if speakers are used!
  • ADC > 90 dB SNR and -72 dB THD+N
  • Line-Out > 100 dB SNR and -85 dB THD+N
  • HP Output > 100 dB SNR and -80 dB THD+N, 62.5 mW max into 16 ohm.
  • Speaker Output > 1.4W per channel, into 8 ohms.
  • Hardware level controls for Headphone Volume, Line In, Line Out. ALSA support.
  • 2x20pin 2.54mm female header included!

Details

  • Made by Fe-Pi
  • HAT form-factor
  • Needs 5v and 3v3 power
  • Uses 6 GPIO pins
  • Communication over I2C
  • 0x0a: SGTL5000XNAA3/R2
  • More Information
  • Buy Now
Fe-Pi Audio Card