CamJam EduKit 3 motor controller board

This motor controller board is part of CamJam EduKit 3 - Robotics but is also available separately from The Pi Hut. It provides two motor outputs for 6V motors using a DRV8833 H Bridge and breaks out most of the unused pins to a female header on top of the board.

Pins that are broken out to the header are as follows: 5v, 3v3, SDA and SCL (for I2C devices), 4, 17, 18, 22, 23, 24, 25, 27, and Ground.

The board expects 4 AA batteries to be used to power the board, although it will accept up to 10V if you have more powerful motors available. A flyback diode is provided to protect your board and Raspberry Pi if you should accidentally wire up the power source the wrong way around.

The motor controller board was designed by Rachel Rayns for The Pi Hut. Educational material was written by Tim Richardson and tested by Michael Horne over at CamJam.

Details Made by PiHut 26 pin header Uses 4 GPIO pins More Information GitHub Repository Buy Now